Step 1: Making Vibration Motor Modules

Step 1: Making Vibration Motor Modules

This step is quite independent of the rest of the glove-making process, so really you can do it at any point along the way. One reason to do it at the beginning though is that the Sugru takes a full day to cure so if you do it earlier on then the vibration motor modules will be ready by the time you need them.

Use some plastic to space the snaps apart the right distance. Mount the vibration motor between the snaps (on the back side) so that the casing of the vibration motor is not touching either metal snap! Solder the leads of the vibration motor to the back sides of the snaps. Use Sugru to cover the vibration motor and the front side of the plastic spacer, so that only the front sides of the snaps are exposed.

Video: Soldering to the vibration motor snaps

Open pack of Sugru, kneed for a bit and split into two equal parts. One for each vibration motor module.

Use some dish-washing soap to give the surface a polished effect:

Video: Covering vibration motor in Sugru

PLEASE NOTE: this design is no longer supported in either hardware or software and you are strongly advised against building this glove at present. Please join our mailing list for updates on a future DIY design.

License

Creative Commons License
The DIY ArduIMU gloves design by mi.mu is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

2 Comments so far

  1. Roald Baudoux on December 12th, 2014

    Hello Hannah,

    Why have you dropped this technique for the glove’s latest versions ?

  2. Hannah Perner-Wilson on December 13th, 2014

    good question. you mean the new motor assembly in the mi.mu collaborator version of the gloves?
    >> http://mimugloves.com/dev-blog/hardware-assembiles/
    the snaps are a great connector when working with electronic textiles as circuit traces. but since we reverted back to a traditional PCB and wire design for the collaborator version, the motors have ended up wired and strain-relieved on little motor boards. this option is working well, but in future e-textile versions of the gloves i’d definitely want to go back to using snaps as both fasteners and electrical connectors.

Leave a Reply